How to install a transfer cut sticker or decal

Clean the surface and wipe dry. Using rubbing alcohol may assist in removing residues or waxes on the surface.
Peel off backing. Often a slow, low angle, diagonal motion works best.
Flip over and carefully position the sticker starting at the top or upper corner...slowly rolling the sticker onto the surface.
Smooth the sticker (credit card or paper towel), and then press hard.
Slowly remove the application mask paper, moving from the upper right corner, and peeling slowly in a low angle, diagonal direction toward the lower left corner.
Congratulations on showing off your new Sea Michigan sticker!

Clean the surface and wipe dry. Using rubbing alcohol may assist in removing residues or waxes on the surface.
Peel off half of the backing, starting at the pre-cut slit. Often a slow, low angle, diagonal motion works best.
Carefully position the half-exposed back and apply to the surface, starting at the edge of the decal.
Carefully remove the other half of the backing and continue rolling the decal onto the surface. Smooth the decal (credit card or paper towel), and then press hard.
Congratulations on showing off your new Sea Michigan sticker!